Making a Stainless Race Buggy
This process is a little dated now, made in 2007, but it will still give the first time buggy builder a guide during the building process
Starting from scratch. The buggy on this page will be the PTW Cougar buggy to replace the PTW Panther. There is always room for improvement, and on this page you can see how, and what I am aiming to do.
The improvements will be, the thicker laser cut plates, improved machined stainless bosses and bearing housing, tilting back rest, and a 60mm by 40mm swan neck. This buggy will be longer, higher, heavier and stronger than the Panther.
Good Luck