Making a Stainless Race Buggy » 71 Side rail plates are bolted to the swan neck, and raised to the correct angle, notice the square at the front making sure everything stays in line

71 Side rail plates are bolted to the swan neck, and raised to the correct angle, notice the square at the front making sure everything stays in line

70 notice that the rear axle is higher than the bottom of the side rail plates in the centre, and the front axle is also higher than the same plates
72 Even though the side rails are now tacked, it is best to fully weld the plates to the side rails while everything is bolted together

This entry was posted on Friday, December 16th, 2011 at 8:06 pm. It is filed under . You can follow any responses to this entry through the RSS 2.0 feed. Responses are currently closed, but you can trackback from your own site.

Comments are closed.