Making a Stainless Race Buggy » 45 View of the top joint, note the end of the small section has been ground round ready to fit the head stock.

45 View of the top joint, note the end of the small section has been ground round ready to fit the head stock.

44 Each end is prepped (angled) ready for welding to allow a full penetration weld.
46 Because the bottom section is nearly parallel to the ground a wedge is cut out of the end to make the seating more comfortable.

This entry was posted on Friday, December 16th, 2011 at 8:05 pm. It is filed under . You can follow any responses to this entry through the RSS 2.0 feed. Responses are currently closed, but you can trackback from your own site.

Comments are closed.