Making a Stainless Race Buggy » 37 Then back to the boring job of buffing the stainless.

37 Then back to the boring job of buffing the stainless.

36 Once the plates have been bent, now is a good time to check the lengths are correct
38 Stainless bosses are made the same diameter as the internal bore of the tube with a 12mm thread 25mm long on the end

This entry was posted on Friday, December 16th, 2011 at 8:05 pm. It is filed under . You can follow any responses to this entry through the RSS 2.0 feed. Responses are currently closed, but you can trackback from your own site.

Comments are closed.