Making a Stainless Race Buggy » 19 Here you can see the 65 degree angle against the plate.

19 Here you can see the 65 degree angle against the plate.

18 Forks legs are cut and mitred to the required length, in this case 45 degrees at the headstock and at the axle plate 65 degrees.
21 Very important at this stage to place a 12mm bar through the plates, to make sure the holes are perfectly square.

This entry was posted on Friday, December 16th, 2011 at 8:04 pm. It is filed under . You can follow any responses to this entry through the RSS 2.0 feed. Responses are currently closed, but you can trackback from your own site.

Comments are closed.